PackshotCreator PackshotStart 360 Quick Start Manual page 12

PackshotStart 360
COMPONENT REPLACEMENT
CONTROL BOARD AND POWER SUPPLY:
Contact a PackshotCreator representative before attempting to access this area of the studio.
01
Remove the acrylic and
Note:
glass turntable platforms and tape
the driving module down to secure
before you proceed to lay the
studio down.
02
To access the control board,
unplug the studio, lay the studio
down. Then remove the 4 black
hand screws and take off the
bottom plate.
03
The power supply sits in the
center.