Advertisement
PREPARATION OF TRUCK TO BE
REPAIRED OR MAINTAINED
Prepare all necessary safety measures to avoid a
possible accident during the course of repair and
maintenance by taking the following precautions:
1.
Park the truck safely.
2. Press emergency shut-off switch and disconnect
the battery.
INSPECTION OF HYDRAULIC OIL CAPACITY
1.
Remove the ten bolts (1). (See Figure 7)
2. Remove covers (2). (See Figure 7)
3. Check the capacity of hydraulic oil in oil tank.
NOTE: During inspection of hydraulic oil
capacity, forks and carriage must be lowered
to the minimum height.
INSPECTION OF ELECTRIC FUSE
1.
Remove the ten bolts (1). (See Figure 7)
2. Remove covers (2). (See Figure 7)
3. Consult the chart to check the current rating of all
fuses, and replace if necessary.
CODE
PROTECTION PURPOSE
FU1
Main Circuit Fuse
FU01
Traveling Control Fuse
USE OF TRUCK AFTER MAINTENANCE
Finish the following operations before using the truck:
1. Clean the truck.
2. Check the brakes.
3. Check the emergency shut-off switch.
4. Check the horn.
MAINTENANCE OF THE TRUCK
OPERATION AND ENVIRONMENTAL SAFETY
1. The instructions in the table in "Maintenance List"
should be performed based on the time interval
specified.
PAGE 5 OF 7
MAINTENANCE CONTINUED
2. To ensure the safety and reliability of truck operation,
3. Any parts replaced, including oils, must be disposed
SAFETY RULES FOR PALLET TRUCK MAINTENANCE
1.
2. CLEANING OPERATION – Flammable fluid is strictly
3. OPERATION OF ELECTRICAL SYSTEM – Maintenance
4. WHEELS – The condition of the wheels will greatly
CURRENT
RATING
5. LIFTING CHAINS – Without lubrication, the lifting
10A
200A
6. HYDRAULIC OIL PIPE – The oil pipe should be
7.
only spare parts from manufacturer should be used.
of according to related environmental protection
regulations.
MAINTENANCE STAFF – Repair and maintenance
should be performed only by qualified professionals.
forbidden in the cleaning of the truck. Before
cleaning starts, safety measures must be taken
to avoid sparking caused by a short circuit. Any
cleaning should be performed after disconnecting
the battery. All electric elements and electronic
assemblies can only be cleaned by compressed air
or by an anti-static brush.
of electrical system of the truck should be
performed by trained professionals only. Before
any maintenance of electrical system, protection
measures to avoid electric shock should be taken by
disconnecting the battery from the truck.
affect stability and driving performance. Wheels
should be replaced in pairs, e.g., both left and right.
chains will wear out prematurely. The time interval
in the maintenance list is applicable for normal
operation. In case of poor operating conditions
(dust, temperature), it is necessary to increase
lubrication accordingly.
replaced every six years.
NOTE: The maintenance cycle stated in
maintenance list refers to normal conditions
with single shift operation. Under dusty
conditions, extreme temperatures or under
multiple operating shifts, the maintenance
cycle should be shortened accordingly.
Please perform maintenance according to the
following table:
CODE
MAINTENANCE SCHEDULE
W1
Every 50 working hours, at least once per week
M3
Every 500 working hours, at least once per 3 months
M6
Every 1,000 working hours, at least once per 6 months
M12
Every 2,000 working hours, at least once per 12 months
0312 IH-3405
Advertisement
