U-Line H-3405 Operating Instructions Manual

H-3405
ELECTRIC PALLET TRUCK
GENERAL SAFETY GUIDELINES
WARNING! Do not operate this truck unless you
have been trained to use it, authorized to do so
and have checked it is in good condition. The
operator should read all of the warning signs and
instructions here and on the truck before using it.
The truck is strictly forbidden to lift or carry a person.
NOTE: Battery must be charged prior to first use.
1. In case of any failure or fault, please stop using the
truck until it can be properly repaired.
2. Do not repair the truck without professional training
and authorization.
3. Protective shoes should be worn when working
with this truck according to local safety regulations.
4. Keep a two-foot distance between the truck and
any person not operating it.
5. Never place any part of your body in the lifting
mechanism or under the forks or bed.
6. Do not operate on uneven ground or in a
dangerous environment.
7. The truck should not be driven on public roads.
8. The truck may only be driven into an elevator or
loading platform with enough load capacity to
support the truck. The operator must confirm this
point before entering elevator or loading platform.
Passengers must enter the elevator after proper
parking of the truck and walk out of the elevator
before moving the truck.
9. The truck should always be driven with the height of
the forks in the lowest position except when placing
or moving a load.
10. The truck should always be parked on a level
surface. The forks must be lowered to their lowest
position. Always turn the ignition to the "OFF" position.
Always remove the ignition key from the electrical
lock when leaving the truck.
PAGE 1 OF 7
1-800-295-5510
uline.com
OPERATING INSTRUCTIONS
11. The truck should not be modified in any way from its
12. Safe operating temperature range: 41–104° F.
13. Charge battery in a dry, well-ventilated area and
TRUCK ON ANOTHER VEHICLE'S LOADING
PLATFORM OR ON A GANGWAY
1.
2. The operator must also check the maximum load
TRUCK ON A RAMP OR INCLINE
1. The forks of the truck should always face the
2. Never turn around or turn the truck sideways on a
ROUTINE CHECKLIST BEFORE START-UP
— Check for any defect of the truck (especially on the
— Check if battery is fixed firmly and cable connected
START-UP OF TRUCK
— Pull out emergency shut-off switch.
— Insert key into electric lock switch and turn clockwise
— Battery capacity meter should indicate the current
— Check to ensure the horn is working correctly.
— Check the brake function on the control handle.
original form.
keep away from any source of fire.
Before the truck is driven from a loading bay and
onto a vehicle, the operator must always check the
maximum load capacity of the gangway. There
should also be suitable devices that prevent the
gangway from sliding.
capacity of the vehicle. There should also be
suitable devices to prevent the vehicle from moving.
up-slope direction.
ramp.
wheels).
properly.
to position "I".
capacity.
0312 IH-3405