Enabling And Disabling Parksense - Jeep Compass 2022 Owner's Manual

136 STARTING AND OPERATING
Front Distance Greater than 47 inches
(inches/cm)
Arcs — Left
Arcs — Center
Arcs — Right
Audible Alert Chime
Radio Volume Reduced
NOTE:
ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audible tone.
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately three
seconds when an obstacle has been detected, the
vehicle is stationary, and brake pedal is applied.
WARNING ALERTS FOR FRONT
47-39 inches
(120 cm) (120-100 cm)
None None
None 1st Solid
None None
None None
No
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be
selected from the Uconnect system Ú page 165.
The chime volume settings include low, medium,
and high.
ParkSense will retain its last known configuration
state through ignition cycles.
39-25 inches 25-12 inches
(100-65 cm) (65-30 cm)
None 3rd Flashing
2nd Flashing 3rd Flashing
None 3rd Flashing
Audible chime increases
None as the objects get close
to the vehicle
E
NABLING
ParkSense can be enabled and disabled
with the ParkSense switch, located on
the switch panel below the Uconnect
display.
When the ParkSense switch is pushed to disable
the system, the instrument cluster display
Ú page 77 will show the "PARKSENSE OFF"
message for approximately five seconds.
The ParkSense switch LED will be on when
ParkSense is disabled or requires service. The
ParkSense switch LED will be off when the system
is enabled. If the ParkSense switch is pushed, and
requires service, the ParkSense switch LED will
blink momentarily, and then the LED will be on.
Less than 12 inches (30
cm)
4th Flashing
4th Flashing
4th Flashing
Continuous
Yes
A D P S
ND ISABLING ARK ENSE