Table of Contents
Advertisement
The engine oil and engine oil filter must
be
replaced
in
scheduled maintenance requirements.
▼ Warm up the engine thoroughly, and
then stop the engine and secure the
motorcycle in an upright position on
level ground.
▼ Remove the wire clip and detach the
TSA shift force sensor from the gear
change knuckle.
B01552
1. Wire clip
2. TSA shift force sensor
▼ Loosen the fasteners and remove
the front sprocket outer cover.
2
B01301
1. Sprocket cover
2. Fasteners
▼ Note the orientation of the wire
guide and the routing of the harness
and hoses through the wire guide for
installation.
accordance
with
1
2
1
MAINTENANCE
▼ Detach
the
side
connector from the oil filter cover.
▼ Loosen the fastener and remove the
engine oil filter cover and wire guide.
3
7
6
B01551
1. Side stand switch connector
2. Fastener
3. Cover
4. Wire guide
5. Engine subharness
6. Fuel tank drain hose
7. Coolant expansion tank drain hose
▼ Place an oil drain pan beneath the
engine.
▼ Remove the oil drain plug and
discard the sealing washer.
B01165
1. Oil drain plug
2. Oil filter
123
stand
switch
5
4
2
1
2
1
Advertisement
Table of Contents
