MAINTENANCE
166
Battery Installation
Make sure the motorcycle is stabilized
and adequately supported.
A correctly supported motorcycle will
help prevent it from falling.
An unstable motorcycle may fall,
causing injury to the operator or
damage to the motorcycle.
Make sure the battery busbar, positive
and negative terminals do not come
into contact with each other.
Do not reverse the positive (+) or
negative (-) terminals.
Shorting the positive and negative
terminals, may cause the battery to
vent gas at a very high temperature.
Venting high temperature gas will
cause irreparable damage to the
motorcycle and or serious personal
injury or death.
Warning
Warning
To install the battery:
▼ Install the battery into the battery
case.
▼ Reinstall the battery strap.
B01221_3
1. Battery strap
2. Hook
▼ Reconnect the battery, positive (red)
lead.
Tighten
39.8 lbf in (4.5 Nm).
▼ Apply a light coat of grease to the
terminal to prevent corrosion.
2
B01222_2
1. Battery positive lead cover clip
2. Battery positive lead busbar cover cap
1
2
the
terminal
to
1