Table of Contents
Advertisement
Warning Lights
Caution
If a red warning light is shown then
the
motorcycle
immediately.
Read
messages and rectify the issue.
If an amber warning light is shown
then the motorcycle does not need to
be stopped immediately. Read any
warning messages and rectify the
issue.
When the ignition is switched on, the
instrument warning lights will illuminate
for 1.5 seconds and will then go off
(except those which remain on until the
engine starts, as described in the
following pages).
For additional warning and information
messages, see page 38.
must
be
stopped
any
warning
GENERAL INFORMATION
Engine Management System
Malfunction Indicator Light (MIL)
The
Malfunction
Light (MIL) for the engine management
system illuminates when the ignition is
switched ON (to indicate that it is
working)
but
should
illuminated when the engine is running.
If the engine is running and there is a
fault with the engine management
system the MIL will be illuminated and
the general warning symbol will flash. In
such
circumstances,
management system may switch to
'limp-home' mode so that the journey
may be completed, if the fault is not so
severe that the engine will not run.
Warning
Reduce speed and do not continue to
ride for longer than is necessary with
the MIL illuminated. The fault may
adversely affect engine performance,
exhaust
emissions
consumption.
Reduced engine performance could
cause a dangerous riding condition,
leading to loss of control and an
accident.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
Note
If the MIL flashes when the ignition is
switched ON contact an authorized
Triumph dealer as soon as possible to
have the situation rectified. In these
circumstances the engine will not start.
31
Indicator
not
become
the
engine
and
fuel
Advertisement
Table of Contents
