rosseto EZ-SERV EZ563 Quick Start Manual

SETTING UP YOUR PRODUCT

1. Carefully remove all parts from packaging and poly bags.
2. Make sure you have all parts listed before discarding packaging.
• 1 Metal Base
• 3 Acrylic Catch Trays
• 3 Stainless Steel Tray Tops
• 6 Containers each one with:
a. Lid
b. PRO-6W Silicon Portion Wheel (1 oz.)
c. Container
d. Label Holder
e. Handle
3. Place table stand on a flat surface facing you.
4.Place the acrylic catch trays on the metal stand. The underside of the tray
should connect to the base. Place the stainless steel tray tops on each
acrylic tray.
5.Fill containers with desired dry product and seal with the lid.
6.Hold the container above the stand with the handle facing you. Carefully
lower the container down to the metal opening, tilted at an angle that
allows the handle to clear through first. The back of the container has a
small notch that aligns with an indent on the bracket to prevent movement
from side to side.
7.Once the handle is cleared through the metal opening, you may tilt the
container carefully back to a full upright position. Then, gently set the
container down directly on the stand.
8.Repeat Steps 5 through 7 for the remaining containers.
9.Attach label holder (d) to bracket as shown in FIGURE (A).
10.Dispense as you please!
NEED ASSISTANCE?
EZ-SERV® Carousel Tabletop Dispenser
Model: EZ563- 6 Container Carousel
METAL STAND
STAINLESS STEEL TRAY TOP
ACRYLIC CATCH TRAY
Please contact our customer service support at (847) 763-1215
and we'll be happy to assist with any assembly questions,
comments, or concerns.
ROSSETO
Visit our website at www.rosseto.com
a. LID:
ITEM # EZL015
b. PADDLE WHEEL
ITEM # EZP021
c. CONTAINER SHELL
ITEM # EZC015
Disclaimer: Acrylic container
will come with transparent
plastic film wrap. Please
remove before use.
d. LABEL HOLDER
ITEM # EZM036
f. HANDLE
ITEM # EZH010
FIGURE A
NOTE: Recommended label size is 2.35x1.4 IN
® 3714 Jarvis Avenue, Skokie, IL 60076