rosseto EZPRO 2 Assembly Instructions

Assembly Instructions for EZPRO 2/3/5 Unit
1. Carefully remove all parts from packaging:
• 1-PRO Stand
• 1-PRO Base
• 1-PRO Tray
• 1.5mm Allen Wrench
• 2, 3 or 5 PRO Containers
I. Pro Lid, Stainless Steel (1)
II. 6WR PRO Silicon Paddle Wheel (2)
III. Regular Nozzle (3)
IV. Container (4)
V. Name Tag (5)
VI. PRO Handle (6)
VII. Mini 1.5mm Screw for Handle (7)
VIII. Plastic Pin (8)
XI. Pro Fresh Lid (9)
2. Remove all PRO Containers (4) from individual
packaging and foam protection
3. Remove all PRO Lids (1) from cardboard insert
before discarding container packaging
4. Insert back of container onto PRO Stand (A), making
sure it locks into place and the container is secure
5. Repeat Step 4 for the remaining containers
6. Place PRO Tray (C) on PRO Base (B)
7. Place PRO Base (B) on PRO Stand (A)
8. Fill containers with desired dry product
9. Place all lids on each corresponding container
10. Dispense as you please!
* IMPORTANT NOTE, PLEASE READ:
Make sure to use long side of Allen wrench to tighten screw. When tightening screw, turn handle so screw hole is facing the bottom
of container towards nozzle for easy access.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(D)
(8)
(9)