Specifications - Sony STR-DH700 Operating Instructions Manual

If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 28). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
In the event of a problem with S-AIR function,
have a Sony dealer check the entire system
together (S-AIR main unit and S-AIR sub
unit).
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
98 GB

Specifications

Amplifier section
Models of area code CEL, CEK, AU
Minimum RMS Output Power (8 ohms, 20 Hz –
20 kHz, THD 0.09%)
Stereo Mode Output Power (8 ohms, 1 kHz,
THD 1%)
Surround Mode Output Power
THD 10%)
1)
Area code
CEL, CEK, AU
2)
Frequency response
See
page 28
page 60
Inputs
Outputs (Analog)
Equalizer
85 W + 85 W
100 W + 100 W
140 W/ch
Measured under the following conditions:
Power requirements
230 V AC, 50 Hz
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Analog 10 Hz – 70 kHz
+0.5/–2 dB (with sound
field and equalizer
bypassed)
Analog Sensitivity: 500 mV/
50 kohms
S/N
(A, 500 mV
Digital (Coaxial) Impedance: 75 ohms
S/N: 100 dB
(A, 20 kHz LPF)
Digital (Optical) S/N: 100 dB
(A, 20 kHz LPF)
AUDIO OUT Voltage: 500 mV/
10 kohms
SUBWOOFER Voltage: 2 V/1 kohm
Gain levels ±6 dB, 1 dB step
1)
2)
(8 ohms, 1 kHz,
3)
: 96 dB
4)
)