Naming Preset Stations - Sony STR-DH700 Operating Instructions Manual

Naming preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 63).
3
Press AMP MENU.
"1-LEVEL" appears on the display.
4
Press V/v repeatedly to select
"4-TUNER".
5
Press or b to enter the
menu.
6
Press V/v repeatedly to select
"NAME IN".
7
Press or b to enter the
parameter.
The cursor flashes and you can select a
character.
8
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
9
Press .
The name you entered is registered.
64
GB
Note (Models of area code CEL, CEK
only)
When you name an RDS station and tune in that
station, the Program Service name appears instead
of the name you entered. (You cannot change the
Program Service name. The name you entered will
be overwritten by the Program Service name.)