System Settings - Sony STR-DA5400ES Operating Instructions Manual

Notes
• It takes some time to output the sound after a
playback operation is performed on the connected
component (e.g., pressing the PLAY button,
pressing the STOP button, pressing the PAUSE
button) due to limitations of the H.A.T.S. system.
The time lag depends on the sound source. This
feature may be ineffective depending on the
component and the sound source, even if you set it
to ON.
• The components connected to the HDMI jack must
support the H.A.T.S. feature.
• When "Audio Out" is set to "TV+AMP," the
H.A.T.S. function may not work, depending on the
component connected or the condition of that
component. In this case, select "AMP" for "Audio
Out."
• The H.A.T.S. function of this receiver works when
a Sony SCD-XA5400ES is connected to the
receiver.
Stream information about the
H.A.T.S. function available
Audio signal input Sampling frequency
Linear PCM 2ch
Linear PCM Multi
DSD
Video Direct
Lets you output the video input signals from
the HDMI IN jack directly to the HDMI OUT
jack.
x OFF
The input signals from the HDMI IN jack are
output through a video processor.
x ON
The input signals from the HDMI IN jack are
output directly.
126
GB
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
44.1 kHz, 48 kHz,
88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz
2.8224 MHz

System settings

Customizes the settings of the receiver.
Screen Saver
Lets you activate the screen saver function for
the GUI menu on the TV connected to the
receiver.
x OFF
The screen saver function is disabled.
x ON
When there has been no operation attempted
for 15 minutes, the screen saver function is
activated automatically.
RS-232C Control
Lets you use this menu for the zone 2/zone 3
operation.
x OFF
x ON
Language
Selects the language for the messages on the
screen.
x English
x Español
x Français
x Deutsch