The Receiver - Sony STR-DA3700ES Operating Instructions Manual

The command modes of both the receiver and
the remote control are those of the factory
default setting (COMMAND MODE AV2).
The receiver and the remote control, on the
contrary, should use the same command mode.
If the command modes of the receiver and the
remote control are different, you cannot use
the remote control to operate the receiver.
Switching the command mode of

the receiver

?/1 2CH/A.DIRECT
1
Press ?/1 to turn off the
receiver.
2
While holding down 2CH/
A.DIRECT, press ?/1 to turn on
the receiver.
When the command mode is set to "AV2,"
"C. MODE AV2" appears on the display.
When the command mode is set to "AV1,"
"C. MODE AV1" appears on the display.
80
GB
Switching the command mode of
the remote control
RM SET
UP
SHIFT
1, 2
1
Press ?/1 while pressing RM
SET UP.
The AMP and ZONE buttons flash.
2
Press AMP.
The ZONE button goes off, the AMP
button keeps flashing and the SHIFT
button lights up.
3
Press the numeric button 1 or 2
while the AMP button is
flashing.
When you press 1, the command mode is
set to COMMAND MODE AV1. When
you press 2, the command mode is set to
COMMAND MODE AV2.
The AMP button lights up.
4
Press ENT/MEM.
The AMP button flashes twice, then the
command mode setting process is
completed.
?/1
AMP
ZONE
ENT/
MEM