Change Receiver Id; Set Output Channel; Input Key Enable/Disable; Lock A Channel - Sony SAS-B65D Service Manual

Change Receiver ID

Set output channel

Input key enable/disable

Lock a channel

• Enable or disable the
• Lock the system on a particular channel.
• Select English or Spanish language menus.
• Enable or disable Caller ID on and off.
PREFERENCES
Antenna
Signal
Prefs
Test
New Card
Upgrade
Features
Exit
Return
If you are using more than one satellite receiver in the same room you may want
to change the receiver ID to avoid any interference. If you are not using the RF
antenna supplied with the SAT-A65A DIRECTV
"50" or "51".
If you are using the RF antenna and RM-Y807 remote control (SAT-A65A only),
the RF ID can be a number from 00 to 15.
1. Press the CODE SET
2a. Changing IR receiver ID: Check that the RF antenna is not connected
to the satellite receiver. Enter the desired receiver ID number, either
"50" or "51", and press the
2b. Changing RF receiver ID: Check that the RF antenna is connected to
the satellite receiver and that you are using the RM-Y807 remote
control (SAT-A65A only). Enter the desired receiver ID number from
"00 to "15", and press the
3. Check that the ID has been successfully set by testing the remote control to
see that it controls that satellite receiver.
Use the Output Channel menu button to toggle between channels 3 and 4,
whichever is unused in your area.
The Input Key menu button allows you to turn the remote control
button on and off.
Use the Channel Set menu button to set the DIRECTV Receiver to permanently
stay on a specific channel. When you enter a channel number (5-0-0, for
example) then select OK, the receiver will always power up on that channel
(channel 500 in this example). The receiver will ignore any attempts to change
the channel. Set this option to "Off" to permit normal channel selection.
button on your remote control.
INPUT
Receiver ID Unit 1
Output Channel
3
On
Input Key
Channel Set Off
Menu Language
English
Color Scheme
Ocean
Translucency
Solid
Caller ID On
Factory Defaults
System Preferences menu pane
®
button on the remote control.
button twice.
SELECT
button twice.
SELECT
Fri, Aug 3 5:15 PM
Receiver, the ID can be either
TV/SAT
Using the menus
25