Speaker Connection; Speaker Setup; Automatic Phase Matching - Sony STR-DA3700ES Operating Instructions Manual

To set a compensation type for the
speakers
You can select the compensation type to be
used for the speakers for each Position.
1
Select the "Position" for which you want
to set the speaker compensation type,
then press .
2
Select the "Calibration Type" you want,
then press .
• Full Flat
Makes the measurement of frequency
from each speaker flat.
• Engineer
Sets the frequency to match that of the
Sony listening room standard.
• Front Reference
Adjusts the characteristics of all the
speakers to match the characteristics of
the front speakers.
• Off
Sets the Auto Calibration EQ to off.
Note
You cannot set the "Calibration Type" for "Position"
for which the measurement results have not been
registered.
To name the Position
1
Select the "Position" for which you want
to name, then press
2
Select "Name In," then press
The soft keyboard appears on the screen.
3
Press V/v/B/b and
character one by one.
4
Select "Finish," then press

Automatic Phase Matching

Lets you set the A.P.M. (Automatic Phase
Matching) function in the D.C.A.C. (Digital
Cinema Auto Calibration) function (page 85).
x OFF
Does not activate the A.P.M. function.
86
GB
.
.
to select a
.
x AUTO
Switches the A.P.M. function on or off
automatically.
Notes
• This function does not work in the following cases.
– "OFF" is selected for the calibration type
(page 85).
– Analog audio signals are input.
– "2ch Analog Direct" is being used.
• The receiver may play back signals at a lower
sampling frequency than the actual sampling
frequency of the input signals, depending on the
audio format.

Speaker Connection

Lets you adjust each speaker manually. You
can also adjust the speaker levels after the Easy
Setup is completed.
The Speaker Settings are only for the current
"Position."
You can make the following settings using the
wizard.
– Settings for the speaker pattern for the
speaker system you are using
– Settings for the SURROUND BACK/
FRONT HIGH/ZONE 2 terminals for a bi-
amplifier connection or a zone 2 connection
("SB Assign")
Note
If the speaker pattern is set so that there are surround
back speakers or front high speakers, you cannot set
the SURROUND BACK/FRONT HIGH/ZONE 2
terminals for a bi-amplifier connection or a zone 2
connection.

Speaker Setup

Lets you adjust each speaker manually on the
Manual Setup screen. You can also adjust the
speaker levels after "Auto Calibration" is
completed.
Select "Level/Distance/Size," then
press .