Smeg SI1F7635B User Manual page 20

20
Problem
comes on.
comes on.
comes on.
and a number come on.
You can hear a constant
beep noise.
Possible cause
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Automatic Switch Off oper‐
ates.
Child Safety Device or Lock
operates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
Flexi4Zone operates. One or
more sections of the func‐
tion mode which operates
are not covered by the cook‐
ware.
Flexi-Heat operates. Two
pots are placed on the flexi‐
ble induction cooking area.
There is an error in the hob.
The electrical connection is
incorrect.
Remedy
Use cookware with a diame‐
ter applicable to the activa‐
ted function or function
mode. Use cookware with a
diameter smaller than 160
mm on a single section of
the flexible induction cook‐
ing area. Refer to "Flexible
induction cooking area".
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Re‐
fer to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Place the cookware on the
correct number of sections
of the function mode which
operates or change the
function mode. Refer to
"Flexible induction cooking
area".
Use only one pot. Refer to
"Flexible induction cooking
area".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.