Elo TouchSystems 4243L User Manual page 26

1) In order to meet emission and immunity requirements, the user must observe the following:
a) Use only the provided I/O cables to connect this digital device with any computer.
b) To ensure compliance, use only the provided manufacturer's approved line cord.
c) The user is cautioned that changes or modifications to the equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
2) If this equipment appears to cause interference with radio or television reception, or any other device:
a) Verify as an emission source by turning the equipment off and on. If you determine that this equipment is
causing the interference, try to correct the interference by using one or more of the following measures:
i. Move the digital device away from the affected receiver.
ii. Reposition (turn) the digital device with respect to the affected receiver.
iii. Reorient the affected receiver's antenna.
iv. Plug the digital device into a different AC outlet so the digital device and the receiver are on different
branch circuits.
v. Disconnect and remove any I/O cables that the digital device does not use. (Unterminated I/O cables are a
potential source of high RF emission levels.)
vi. Plug the digital device into only a grounded outlet receptacle. Do not use AC adapter plugs. (Removing or
cutting the line cord ground may increase RF emission levels and may also present a lethal shock hazard to
the user.)
If you need additional help, consult your dealer, manufacturer, or an experienced radio or television technician.
III. Agency Certifications
The following certifications and marks have been issued or declared for this touch display:
•
Argentina S-Mark
•
Australia RCM
•
Canada CUL, IC
•
China CCC
•
Europe CE
•
Japan VCCI
User Manual – 32/42/43/5543L Series IDS
•
Korea KCC, e-Standby
•
Mexico CoC
•
Russia EAC
•
Taiwan BSMI
•
United States FCC, UL
SW601960 Rev. G, page 26 of 31