Monogram Advantium CSB912 Installation Instructions Manual page 10

Flush Mount Installation Preparation
PREPARE THE OPENING
The Advantium Built-In Oven can be installed
beside another Advantium Built-In Oven in a
side-by-side combination.
Double Advantium Built-In Oven
Installation:
Cut the opening in a cabinet to the dimensions
shown.
• Center divider acts as cleat for side of each
respective unit. Only one additional side cleat
needed per oven cutout.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
*See table for desired reveals on sides and
between unit.
Dimension 1/8" Reveal
G 53-7/8"
H 1-5/8"
I 26-1/8"
PREPARE THE OPENING
Installation under a 30 or 36 Cooktop or Countertop:
Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size.
See the label on top of the oven for approved cooktop models. This oven requires a separate from the cooktop,
properly grounded 15-Amp, 120-Volt, 60Hz power supply. Use a 36 or wider base cabinet.
23-1/2
4 High
Toekick
10
1/4" Reveal
54-1/4"
1-3/4"
26-1/4"
1-1/2 Min.
Cooktop
Cooktop
J*
20-1/2"
36-3/4"
25
Countertop
20-1/2"
Cooktop height including
depth of electrical box
on some models. Refer
to cooktop installation
instructions.
No minimum clearance
required between cooktop
and oven.
*See table for desired reveals on sides.
Dimension
J
23-1/2" min.
G*
H*
I*
I*
1 1/4"
Construct solid bottom - Min. 3/8"
plywood supported on all four
sides. Must be able to support
weight of oven and contents.
36
Height
*1/8" reveals on
sides and top
1/8" Reveal 1/4" Reveal
27" 27-1/4"
31-2000355 Rev. 2