Page 2
APPLICATION 2. The pump should be mounted so the deck is at least 6½" above the floor. This will allow clearance for the tank to be removed later for cleaning. The Myers Condensate Pump is designed to automatically remove the liquid from an air conditioner evaporative coil and/or a gas condensing warm air furnace.
Page 3
NOTE: The stripped white wires extending from the side d. As the water level nears the top of the unit the overflow of the top housing are NOT powered. safety switch should activate, breaking the thermostat circuit to the appliance (or triggering an alarm circuit, These are used in Step 2.
Page 4
Warranty is effective only if Pentair Myers authorized control panels are used. All seal fail and heat sensing devices must be hooked up, functional and monitored or this warranty will be void. Pentair Myers will cover only the lower seal and labor thereof for all dual seal pumps. Under no circumstance will Pentair Myers be responsible for the cost of field labor, travel expenses, rented equipment, removal/reinstallation costs or freight expenses to and from the factory or an authorized Pentair Myers service facility.
Need help?
Do you have a question about the Myers MCU20S and is the answer not in the manual?
Questions and answers