Output Resolution - Sony BDV-Z7 Operating Instructions Manual

• For details about video output resolution, see
"Video Output Resolution" (page 91).
8
Press or c.
The Setup Display for video output
resolution selection appears. For details, see
[Output Video Format] (page 69).
When you select [HDMI] in Step 7
Select from [Auto], [480i/576i], [480p/
576p], [720p], [1080i], or [1080p].
When connecting the HDMI OUT jack and
other video output jacks at the same time,
video signals may only output from the
HDMI OUT jack when [Auto] or [1080p] is
selected.
When you select [Component Video] in
Step 7
Easy Setup - Component Resolution
Select the resolution to output to the TV.
The new resolution displays for 30 seconds when this setting is changed.
Check that there are no problems with the video.
Nothing is displayed on the screen if the resolution is incorrect.
Select from [480i/576i], [480p/576p],
[720p], or [1080i].
When you change the video

output resolution

A picture is displayed in the selected
resolution for about 30 seconds, then the
display asks for confirmation.
Follow the on-screen instructions and go to
the next step.
Note
• If the picture is distorted or no picture appears,
wait for about 30 seconds without pressing any
buttons. [Is this resolution OK?] appears. Select
[Cancel]. The display returns to the resolution
setting screen.
30
GB
• If the selected video output resolution is
incorrect, no picture appears on the screen. In
this case, press and hold N and Z on the
control unit for more than 5 seconds to reset the
video output resolution to the lowest resolution.
To change the video output resolution, set
[Output Video Format] in [Video Settings]
(page 69).
9
Press or c.
The Setup Display for selecting the aspect
ratio of the TV to be connected appears.
Easy Setup - TV Type
Select the screen aspect ratio to match your TV.
10
Press X/x to select the setting that
matches your TV type.
• [16:9]: If you have a wide-screen TV or a
4:3 standard TV with a wide-screen mode.
(page 68)
• [4:3]: If you have a 4:3 standard TV.
(page 68)
11
or c.
Press
When you connect the system and TV
with an HDMI cable
The Setup Display for the [Control for
HDMI] function appears. Go to Step 12.
When you do not connect the system
and TV with an HDMI cable
The Setup Display for [BD Internet
Connection] appears. Go to Step 14.
12
Press X/x to select the setting for the
Control for HDMI function.
Easy Setup
- Control for HDMI
You can operate this unit in conjunction with a TV connected by HDMI.
Check your TV settings when using this function.
On
Select [On] to use the [Control for HDMI]
function (page 58) when connecting Sony