Electrolux SB 318 N User Manual page 52

52 electrolux
Remove the lower door.
Remove using a tool the cover (b1).
Unscrew the lower hinge pivot (b2)
and the spacer (b3) and place them
on the opposite side.
Re-insert the cover (b1) on the
opposite side.
Disassemble
elements (d2,d3) by unscrewing the
screw (d4) .
Remove stoppers in both doors
(d5,d6).
Reverse the door locking elements
(d2,d3) , move to the other side of the
other door and fix by screwing in the
screw (d4) .
Re-insert the stoppers (d5,d6) on the
other side of the doors.
GB
the door locking
Remove the left-hand cover pin of the
middle hinge (m3,m4) and move to the
other side.
Fit the pin of the middle hinge (m5)
into the left-hand hole of the lower
door.
Re-insert the lower door on the pivot
pin (b2).
Re-screw the middle hinge (m1) on
the opposite side . Do not forget the
plastic spacer (m2) inserted under the
middle hinge.
Re-insert the upper door on the
middle hinge (m5).
Make sure that the edges of the doors
run parallel to the side edge of the
appliance.
Position and fix the upper hinge (you
can find them in the instruction for use
bag) on the opposite side (t6).
t6
Insert the panel (t7) (that can be found
in the instruction for use bag).
Open the upper door, attach the top
cover (t2) using screws (t1). Insert the
magnet (d7). Close the door.
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
t7