Installation - Sharp FU-28H-A Installation Manual

INSTALLATION

FOR APPROPRIATE INSTALLATION
To remove room odour
Installing the unit high up on the wall is most effective.
To remove room dust
Comparatively large dust particles such as pollen and house dust collect in the lower strata of the
room air.
Select a location in the room where the air circulation is good.
This improves the cleaning performance and causes Plasmacluster ions to spread throughout the
room.
Operating Conditions
Please operate the unit under the following conditions.
It is recommended to use the unit in a room where the temperature is in the range of 0 - 35C°.
Avoid locations where the unit is exposed to condensation, due to drastic temperature changes.
Determine the mounting location
1
Leave space around the bracket referring to the drawing below. The unit cannot
be mounted if there is insufficient spacing around the bracket.
70cm or more from
side wall
Installation Cautions
• Before fixing the wall mounting bracket, make sure there is nothing that could obstruct installation of the unit.
Then fix the wall mounting bracket through screw holes with the supplied wood screws.
• Install the unit on a wall, wooden pillar, crosspiece or the like that is flat and strong enough..
• If the wall is weak or made of concrete, have the unit installed by a specialist such as an electric appliance
store.
• Avoid locations near inverter lamps or where the unit is exposed to direct sunlight.
Center line of Wall mounting bracket
Screw Holes
60mm
3mm
Wall mounting bracket
Size of main unit
Power cord
Free Standing Installation.
In case you prefer free
standing installation, optional
stand FZ-FC1TS is available.
Center line of
main unit
16mm
Screw Holes
330mm
482mm (Size of main unit)
E-6
92mm
70cm or more from
side wall
Center line of main unit