Page 1
PURIFICADOR DE AIRE MANUAL DE INSTALACIÓN MANUAL DE USO PURIFICATORE DELL’ARIA MANUALE D’INSTALLAZIONE MANUALE OPERATIVO Wall-mounting type LUCHTREINIGER Wandmontage Type mural IINSTALLATIEHANDLEIDING De montaje en pared GEBRUIKSAANWIJZING Tipo da montare sul muro Wandmodel *Plasmacluster is a trademark of Sharp Corporation.
SPECIFICATIONS ......... E-15 TROUBLE SHOOTING ......E-16 HEPA Filter Thank you for purchasing the SHARP FU-28H. Active Carbon Filter Please read this manual carefully for the correct usage information. Before using this product, be sure to read the section: “Important Safety In- structions.”...
Electrical shock from bad insulation and / or fire from short circuit may occur as a result. • If the power cord is damaged, it must be replaced by the manufacturer, its service agent, Sharp authorized service or similarly qualified person in order to avoid a hazard.
REMOTE CONTROL LIMITATIONS DO NOT USE THE REMOTE CONTROL IN THE FOLLOWING LOCATIONS: • Any location where there is inverter lighting equipment or electronic spontaneous lighting equipment The remote control may become inoperative. In this case, move away from such lighting equipment or change direction.
PART NAMES MAIN UNIT DISPLAY Plasmacluster Indicator Light Power ON/OFF button Fan Speed Indicator Lights Fan Control button OFF Timer Display Indicator Lights OFF Timer button Remote Control Receiver Odour Sensor Filter Frame HEPA Filter (white) (with Microbial Control Filter)(blue) Active Carbon Filter (Deodorizing Filter) Stainless Steel Pre-Filter...
PREPARATION INSERTING BATTERIES IN THE REMOTE CONTROL Remove the back cover Press and slide the back cover to remove. Insert batteries Insert batteries with as shown below. Close the back cover About the batteries • The battery life is about 1 year. •...
INSTALLATION FOR APPROPRIATE INSTALLATION To remove room odour Installing the unit high up on the wall is most effective. To remove room dust Comparatively large dust particles such as pollen and house dust collect in the lower strata of the room air.
Page 9
Mount wall mounting bracket • Mount the bracket using the included wood screws so that it is maintained level. Installation on a concrete, block or mortar surface Drill holes of at least 35 mm depth and 5 mm diameter into the wall, drive in Fisher plugs, and fix the unit with wood screws.
Page 10
INSTALLATION Before starting the wall installation, be sure to remove the front panel and filter frame. Filter Frame Front Panel Install the unit on the wall. Place the unit facing up, remove the Front Air Outlet Panel and Filter Frame. Adjust the length of the power cord.
Apply a mark (tape, etc.) 8 cm above both ends of the wall mounting bracket. Lift up the unit so that the hooking holes on the unit are aligned with the marks, hook the unit onto the wall mounting bracket and slide it to the right.
Be sure to remove the filters from the FILTER INSTALLATION plastic bags before using the unit. How to Remove the Stainless Remove the Pre-Filter, Steel Pre-Filter Active Carbon Filter and HEPA Filter from the Filter Frame. Tabs Pre-Filter Active Carbon Filter HEPA Filter Filter Frame Remove the Active Carbon...
Page 13
Mount the Filter Frame to the main unit. Filter Frame Fill in the usage start date on the Date Label. Use the date as a guide for the Filter Replacement schedule. Date Label Claw Claw socket Mount the Front Panel to the main unit.
OPERATION For the first 30 seconds after the plug is inserted into the wall outlet, the unit will check the conditions of the air. • Auto Operation Odour sensor checks the amount of impurities in the air and the fan speed switches automatically.
Plasmacluster Ion Operation While the product is in operation, the unit will constantly discharge approximately the same amount of Positive and Negative cluster ions. This is effective for reducing some airborne mold. REMOTE CONTROL OPERATION POWER ON/OFF button • Used to start AUTO operation (short beep) and stop operation (long beep).
If dust or odours cannot be removed easily, replace the filters. (Refer to HOW SHARP AIR PURIFIER WORKS E-1) Guide for filter replacement timing • The following filter life and replacement period is based on the condition of smoking 10 cigarettes per day, reducing the dust collection/deodorization power to half compared with that of new filters.
MAIN UNIT To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to remain, they may become hard to clean. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Do not use volatile fluids Benzene, paint thinner, polishing powder, etc., may damage the surface.
TROUBLESHOOTING Before calling for repair, please review the list below, since the problem may not be a unit malfunction. SYMPTOM REMEDY (not a malfunction) • Have the batteries been depleted? The Remote Control does not • Are the batteries inserted correctly? work •...
Page 20
SHARP CORPORATION Printed in Japan TINS-A119KKRZ 04BK 1...
Need help?
Do you have a question about the FU-28H and is the answer not in the manual?
Questions and answers