Related Manuals for TransTank FireBoss
Summary of Contents for TransTank FireBoss
- Page 1 FireBoss ™ Operator’s HandBook w w w . t t i . c o m . a u Manufacturer of “The Safest Tanks in Motion”...
-
Page 2: Table Of Contents
General Information Specifications Description Machine Limitations Driving Stability Operating Instructions Before first use Pump Operation Filling the Tank FireBoss Operation Risk Assessment Maintenance Periodic Checks Maintenance Schedule Trouble Shooting Warranty Warranty Policy What this Warranty Does Not Cover? How to Obtain Service Under this Warranty? Warranty Limitations w w w.tti.com. - Page 3 The FireBoss unit is supplied complete, tested and ready to go. TTi recommends that only water be used in the FireBoss unit. TTi warrants that the FireBoss has been designed and built for its intended purpose for firefighting and dispensing water, such as tree watering.
-
Page 4: Safety
FireBoss ™ Product HandBook Safety This manual is intended for use by personnel experienced in the use of this and similar equipment. Read and understand this manual before attempting to operate or perform routine maintenance on this equipment. Your safety is of prime priority. -
Page 5: General Safety Instructions
7. Ensure the capacity of the vehicle is suitable for the loaded mass of the FireBoss. Refer to the vehicle’s operator manual for safe working loads and relevant safety instructions. Do not exceed the carrying and braking capacity as specified by the vehicle manufacturer. -
Page 6: General Information
Auxiliary freshwater tank with tap for handwashing Description The TTi FireBoss is designed to carry and distribute water using a self-contained pump and hose reel dispensing system, refer to Figure 2, which shows the Standard unit. The FireBoss is configured in two different styles, both designed to fit into the trays of UTVs: •... - Page 7 Honda GX50 4-stroke recoil (pull) start engine. Frame The chassis frame of the FireBoss unit is an all steel, fully welded construction and hot dip galvanised for corrosion resistance. The Standard FireBoss is mounted to the frame via metal straps, while the Compact FireBoss is bolted to the frame.
-
Page 8: Machine Limitations
Operating Instructions Before first use Your FireBoss Low Profile UTV Fire Fighting Unit is delivered fully assembled. Before use, it needs to be set up using the following instructions: • Complete the warranty registration online at www.tti.com.au/warranty-registration, or use the Warranty Registration Card at the back of this handbook. -
Page 9: Pump Operation
• Position your FireBoss onto the vehicle and mount securely, either using tie-down straps located into the tie-down recesses or lugs on both sides of the tank, depending on configuration, refer to Figure 2 and Figure 3 for locations. -
Page 10: Filling The Tank
FireBoss ™ Product HandBook If the FireBoss is not going to be used within the next few hours, shut the system down by turning the fuel tap to OFF. Figure 3 – Engine Start-up Filling the Tank The FireBoss tank is filled as follows: CAUTION: The FireBoss unit is designed for water use only. -
Page 11: Fireboss Operation
Unlock the hose reel then pull out the required length of hose off the reel. Check that the hose nozzle is closed. Note: The pump is self-priming due to the direct coupling to the FireBoss tank. • Start the pump (referring to the procedure above) and adjust engine speed. -
Page 12: Risk Assessment
FireBoss ™ Product HandBook Risk Assessment Task Hazard Risk Control Measure/Mitigation Partially fill the tank Manual handling; Medium Concentrate on task; follow safe with water, start the slips, trips or falls; manual handling techniques: pump engine & test petrol fumes; fingers •... -
Page 13: Maintenance
Check for any signs of fuel or oil leaks. If detected, investigate and rectify immediately. • If the FireBoss is to be stored for an extended period, ensure the tank and all pipelines are empty and are not pressurised. Store the unit is a clean, dry and well-ventilated area. - Page 14 TTi recommends photocopying these schedules in order to keep a detailed log of all maintenance tasks. A copy of these schedules will be required to support any warranty claim. Daily tasks The following tasks are to be undertaken daily, or prior to each use, of the FireBoss unit. Task Notes...
- Page 15 FireBoss ™ Product HandBook Three Monthly tasks The following tasks are to be undertaken every three months or 50 operating hours, whichever occurs first. Task Date Signed All Daily, Weekly and Monthly tasks Inspect the air filter, replace if clogged or damaged...
-
Page 16: Trouble Shooting
Task Date Signed All Daily, Weekly, Monthly, 3-Monthly, 6-Monthly and 12-Monthly tasks Trouble Shooting If a fault develops with the FireBoss, the following trouble shooting table provides guidance to identify and rectify the problem. Possible Problem Remedy cause Pump will not feed water... -
Page 17: Warranty
FireBoss ™ Product HandBook Warranty Warranty Policy TTI will, at its option, repair or replace without charge any part covered by this warranty which is found to be defective in material and/or workmanship within one (1) year after date of sale to the original retail purchaser. - Page 20 Scan to view our PDF Handbook online www.tti.com.au 1800 816 277 sa l e s@ tt i.c om.au P O B ox 1 37, N at ha li a , V I C , 3 63 8 M ur ray Va l l ey H w y, N ath a l i a , V I C 363 8 Quality Checked By: Proudly Built By: Signature...
Need help?
Do you have a question about the FireBoss and is the answer not in the manual?
Questions and answers