Control Assembly; Removing The Control Assembly; Replacing The Control Assembly - Kurzweil CUP2 Service Manual

Disassembly/Assembly

Control Assembly

The Control Assembly includes a bracket that attaches the assembly to the cabinet, the Control

Panel Board, and the control panel enclosure that slides in and out like a drawer.

Figure 4-8

1. Remove the four screws that secure the Control Assembly to the cabinet.

Caution: Do not lower the Control Assembly more than a couple of inches, there is a cable

connected to the Control Panel Board.

2. Lower the Control Assembly and disconnect the at ribbon cable from the Control Panel

3. Place the Control Assembly on your work surface.

1. Hold the Control Assembly in position and connect the at ribbon cable from the Interface

2. Install the four screws that secure the Control Assembly to the cabinet.

4- 12

Control Assembly hardware

Board.

Board to the Control Panel Board. If you removed a cable locking clip from the connector,

be sure to reinstall it.

Table of Contents

Show Quick Links