Removing A Woofer; Replacing A Woofer - Kurzweil CUP2 Service Manual

Removing a Woofer

The woofers are located in the lower front portion of the CUP2 cabinet. Velcro strips,
positioned at each corner, secure the grille to the CUP2 cabinet.
1. Gently pull the grille to separate the Velcro strips.
2. Remove the grille and set it aside.
3. Remove the four screws that secure the woofer to the cabinet.
4. Lift the woofer a couple of inches out from its opening in the CUP2 cabinet and disconnect
the cables connected to the woofer terminals. Be sure to note the location of each wire to
avoid reversing them when you reconnect them.
5. Remove the woofer.
Figure 4-7

Replacing a Woofer

1. Position the woofer at the opening in the CUP2 cabinet and connect the cable to the
terminals on the woofer.
2. Seat the woofer in the opening. Be sure the cables are tucked neatly inside the cabinet.
3. Install the four screws to secure it.
4. Replace the grille.
CUP2 woofer and grille location
Disassembly/Assembly
Cabinet Electronics
4- 11