Spray Nozzle; Water Filter Drain Valve; Water Drain Plug - Toto WASHLET TCF6632G NW1 Series Instruction Manual

Maintenance
If you think the water pressure has weakened

1. Spray Nozzle

General lime scale remover
(liquid)
Remove the spray nozzle from the wand.
1
(1) Press .
 The wand extends.
(2) While holding the wand with a
hand, press on both sides of
the spray nozzle and slide it.
 Do not pull with undue force.
(May cause damage or malfunction.)
Install a spray nozzle (for replacement).
2
Check that the gasket (black) is
attached.
(1) Hold the wand by hand and slide the replacement spray nozzle along the guide
and push it in.
 Install correctly until a click sound is heard.
 Do not push with undue force. (May cause damage or malfunction.)
Guide
(2) Press .
 The wand retracts.
 Water comes out from around the wand.
Cleaning the blocked Nozzle
Remove the spray nozzle and immerse it in general lime scale remover (liquid).
 Do not disassemble the spray nozzle. (May cause malfunctions.)
26
(Approximately once every 6 months)
Other detergents
Wand
Spray nozzle
Gasket
2. Water Filter Drain Valve, Water Drain Plug
<The water pressure is still weak even after cleaning the spray nozzle>
Neutral kitchen
detergent
Close the shutoff valve. (P.32)
1
 The water supply stops.
CAUTION
Do not remove the water fi lter drain
valve while the shutoff valve is open.
(Otherwise, water may leak out)
Extend the wand (Step
2
in "Wand" on page 25) and
press again to
retract the wand.
(Release the pressure from the water supply pipe.)
 Water comes out from around the wand.
Unplug the power plug.
3
Switch the breaker on the
distribution board to OFF.
(Electrical
box type, Concealed power connection type)
Remove the water fi lter drain valve.
4
 Loosen with a fl at-head screwdriver and then pull.
Water fi lter
drain valve
Loosen the water drain plug
5
until its threads lose the grip.
 Water comes out from around the wand
(it takes about 3 minutes to complete draining).
CAUTION
●Do not disconnect the water drain plug
until draining is completed.
(Otherwise, water may leak out)
Loosen

Water drain plug

(Approximately once every 6 months)
Remove the water drain plug.
6
Clean the fi lter with a tool
7
such as a toothbrush.
 Also, remove any dust from inside the hole.
Filter Filter
Push in the water drain plug
8
and water fi lter drain valve
and tighten them securely
with a fl at-head screwdriver.
Insert the power plug.
9
Switch the breaker on the
distribution board to ON.
(Electrical
box type, Concealed power connection type)
 The POWER LED lights up.
Open the shutoff valve. (P.14)
10
Discharge water from the wand.
11
(Step in "Resupplying the
3
Water" on page 31)
27 27