Programming Mode - LG FH0C7FD3S Owner's Manual

PROGRAMMING MODE

: You can check machine information or change setting on "Program setup", "Collect Information
Data", "Diagnostic Test".
How to enter "Programming mode"
You can enter programming mode only for Idle
state and pause state.
- OPL/Coin/Card Type
1) Push the 90°C (194°F) & 60°C (140°F) button
at the same time.
2) Push the 75°C (167°F) button 3 times.
3) Push the Start button.
4) Display will show "
- Card type
1) Insert service card.
2) Display will show "
- Coin type
1) Disassemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of
the coin box.
4) Display will show "
Coin Box Key
Coin Vault
Openings close
- Coin type -
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type.
• Price setting varies by country
• Set your country from
• After EEPT, reset your country (Default country is EUK)
".
"
".
insert debit Card
- Card type -
mode (Refer How to enter the
PrOGrAMMiNG MOdE
How to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
Press Button
Move to upper level or
90°C (194°F)
Comes back to Idle State
Move to the mode in the
75°C (167°F)
Move to the modes in the
60°C (140°F)
Start Enter the selected mode
)
23
Description
same level (+)
same level (-)
- OPL type -