Table of Contents
Advertisement
PROGRAMMING MODE –SETUP MODE
Setup Mode :
You can change washer vend price, cycle time, and cycle parameters, etc.
Entering setup mode
- Coin type – Turn on/off toggle switch.
- Card type – Insert the service card.
- All Types – 1) Push the Hot & Cold button at the same time.
2) Push the Warm button 3 times.
3) Push the Start button.
- Then, the washer displays
1. how to change regular price.
Enter setup mode.
You will see LqC1
NOTE
• Price setting varies by country
• Set your country from
• After EEPT, reset your country (Default country is EUK)
(display)
.
Press the Hot button.
Press the Warm or the Cold button until
in the display.
Press the Start button.
Press the Start button.
Display previous regular price.
Press Warm(+) or Cold(-) button to set the regular price.
(The vend price can be set from 0~10.00 in 0.1
increments.)
Press the Start button.
The machine sets up the regular price, then advances
to the next process automatically.
1. Continue to set up the next price.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the Hot button twice.
mode (Refer How to enter the
PROGRAMMING MODE - SETUP MODE
Button
Display
appears
)
25
Advertisement
Table of Contents
