Installation Certificate - C-TEC XFP502/X User Manual

Networkable analogue addressable fire alarm control panel
Hide thumbs Also See for XFP502/X:
Table of Contents

Advertisement

XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
BS5839-1 recommends that certificates be issued for all aspects of the fire alarm system including design,
installation, commissioning, acceptance, verification (optional) and maintenance. Therefore, before this user
manual is handed over, the following installation certificate and the commissioning certificate (overleaf) should
be completed as appropriate by the relevant installation/commissioning engineer(s). Please ensure that the
System Set-Up Data Chart on page 20 and the relevant parts of the Fire Alarm Log Book on page 21 are also
completed as appropriate. For countries outside the UK, different certification requirements may apply.
Address:
I/we being the competent person(s) responsible (as indicated by my/our signatures below) for the installation of
the fire alarm system, particulars of which are set out below, CERTIFY that the said installation for which I/we have
been responsible complies to the best of my/our knowledge and belief with the specification described below and
with the recommendations of Section 4 of BS5839-1, except for the variations, if any, stated in this certificate.
Name (in block letters):
Position (in block letters):
Signature:
Date:
For and on behalf of:
Address & postcode:
The extent of the liability of the signatory is limited to the system described below.
Extent of installation work covered by this certificate:
Specification against which the system was installed:
Variations from the specification and/or Section 4 of BS5839-1 (see BS5839-1, Clause 7):
Wiring has been tested in accordance with the recommendations of Clause 38 of BS5839-1.
Test results have been recorded and provided to:
Unless supplied by others, the "as fitted" drawings have been supplied to the person responsible for
commissioning the system {see Clause 36.2m) of BS5839-1:
XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000510 Rev 1 • Page 27 of 28
www.acornfiresecurity.com
Certificate
of INSTALLATION
for the fire alarm system at:
www.acornfiresecurity.com

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xfp502/hXfp501/xXfp501/hXfp

Table of Contents