Displaying Fire, Fault, Disablement And Test Events; Testing The Panel's Lamps; Displaying And Clearing The Panel's Alarm Counter - C-TEC XFP502/X User Manual

XFP NETWORKABLE ANALOGUE ADDRESSABLE FIRE ALARM PANEL
When in access level 2 (see page 14) the panel's authorised user menu is displayed (see picture below)
which can be navigated using the panel's scroll (
appropriate.
Each menu option available at access level 2 is explained in detail below.
ENTER ACCESS LEVEL 3
DISPLAY FIRE EVENTS
DISPLAY FAULT EVENTS
DISPLAY DISABLEMENTS
DISPLAY ZONES IN TEST
LAMPS TEST
DISPLAY ALARM COUNTER
SET TIME/DATE
EVENT LOG FUNCTIONS
SET/CLEAR DISABLEMENTS
CHANGE ACCESS LEVEL 2 CODE
Enter Access Level 3
Access Level 3 is the panel's engineering/programming level. ON NO ACCOUNT SHOULD ACCESS LEVEL
3 BE ACCESSED BY ANYONE BUT AN AUTHORISED SYSTEM ENGINEER. A FIRE PANEL IS A PIECE OF LIFE
SAFETY EQUIPMENT AND UNAUTHORISED ACCESS MAY AFFECT THE WAY THE PANEL FUNCTIONS,
ENDANGER LIFE AND VOID ITS WARRANTY. If you are an authorised engineer, details of access level 3
can be found in the panel's separate Engineering manual.

Testing the Panel's Lamps

This function tests the panel's lamps (its LED indicators and display) to ensure they are working correctly.
When selected, press the Accept
for approximately two seconds and its display will progressively block fill. The panel's internal sounder
(if enabled) will also sound. Upon completion, the panel will return to the main access level 2 menu.
If any of the indicators fail to illuminate or the display does not function correctly, report the fault(s)
to the designated site engineer and make a note of it in the fire system's log book.

Displaying and Clearing the panel's alarm counter

This function displays the total number of times the panel has been in a fire alarm condition. When
selected, press the Accept
has been in a fire condition since it was installed AND the total number of times it has been in alarm
since its alarm counter was last cleared, for example:
Total Alarms = 12
Alarms since 01/01/05 = 7
3
Press the Escape button to return to the main access level 2 menu or, to clear the alarm counter,
4
press the Accept button. A window similar to the one overleaf will appear:
Clear to today's date?
Alarm since 01/01/05 = 7
4
Press the Accept button once and the alarm counter will reset and start counting any new fire
conditions from today's date (assuming that the date programmed into the panel is today's date). A
short confirmation message will confirm the change has been made before the display returns to the
main access level 2 menu.
XFP USER MANUAL & LOG BOOK • Approved Document No. DFU2000510 Rev 1 • Page 15 of 28
www.acornfiresecurity.com
DISPLAY ALARM COUNTER
Clear to todays date?
PRINT EVENT HISTORY?
DISPLAY EVENT HISTORY?
RESET EVENT HISTORY?
ENABLE/DISABLE ZONES
ENABLE/DISABLE SOUNDERS
ENABLE/DISABLE OUTPUTS
ENABLE/DISABLE RELAYS
ENABLE/DISABLE DEVICES
ENABLE/DISABLE FAULT RELAY
ENABLE/DISABLE OUTPUT DELAYS
4
button and all of the panel's LED indicators will illuminate steady
4
button and the display will show the total number of times the panel
www.acornfiresecurity.com
56 4
), Accept( ) and Escape (
The menu options shown in
bold will only appear if
relevant to the panel's status.
For example, the DISPLAY
FIRE EVENTS function will not
show if there are no active
fire conditions on the system.
If any of these bold menus
appear, refer to their listings
in access level 1 (pages 12-13)
for details of how they work.
3
) buttons as