Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Trynex SnowEx SD-600
Summary of Contents for Trynex SnowEx SD-600
- Page 1 Owner’s Manual This Manual Must Be Read Before Operating The Equipment SD-600 Serial No. X2-100038 and higher SD-1400 Serial No. X3-100019 and higher CUSTOMER COPY Madison Heights, Michigan 48071 800-SALTERS www.snowexproducts.com © TrynEx International 2013 (REV B) F50729A...
-
Page 2: Table Of Contents
Troubleshooting ......................................8 Notes .........................................9-11 Have a question or need assistance? SnowEx Customer Care (800) SALTERS or (248) 586-3500 Monday trough Friday 8:00 AM to 4:30 PM EST Fax: (248) 691-8378 E-mail: customercare@trynexfactory.com Website: www.snowexproducts.com © TrynEx International 2013 (REV B) F50729A... -
Page 3: Introduction
Control Module Serial # ______________________________ 1-800-725-8377 trynexfactory.com Control Pendant Serial # ______________________________ Model No. SD-600 Date Purchased _____________________________________ Dealer where purchased ___________________________________________________ Serial No. X2-100038 See separate Warranty Information Sheet for your warranty coverage. Manuf. 2013 © TrynEx International 2013 (REV B) F50729A... -
Page 4: Safety
Never leave material in hopper between storms, or when storing. Ice melters are hygroscopic and will attract moisture and harden up. Empty the spreader and clean it after each use to prevent ice melter from building up and covering metal parts, causing corrosion. © TrynEx International 2013 (REV B) F50729A... -
Page 5: Operating Instructions
Use the On/Off button to turn the spreader off between jobs. The Start/Stop pauses spreading, but the vibrator will stay on. Use Start/Stop for when you need to pause spreading for a short time. Use Blast to momentarily increase the application rate – the spreader will operate at full speed until the button is released. © TrynEx International 2013 (REV B) F50729A... -
Page 6: Attaching To Vehicle
Leave these baffles at the factory setting until you have run some material through the spreader at different speeds. The Baffles may need adjusted for different materials, or if the Distribution Shaft is getting too much material, due to an easily flowing material. Use an 1/2” wrench for the bolts. © TrynEx International 2013 (REV B) F50729A... -
Page 7: Maintenance Instructions
Before putting your spreader away, perform a very thorough cleaning, lubricate bearings, and spray oil on metal parts. Apply a pro- tective plastic conditioner to the hopper and lid to protect them from the elements. Put Dielectric Grease on all plugs and connections prior to storage. © TrynEx International 2013 (REV B) F50729A... -
Page 8: Troubleshooting
On/Off Switch Lights, No Display Controller not connected Check connections at Control Module No Display, On/Off Switch does not light up No Power to Controller Check for Cuts in Battery Harness Test Controller (Contact Dealer) © TrynEx International 2013 (REV B) F50729A... -
Page 9: Notes
Notes © TrynEx International 2013 (REV B) F50729A... - Page 10 Notes © TrynEx International 2013 (REV B) F50729A...
- Page 11 Notes © TrynEx International 2013 (REV B) F50729A...
- Page 12 www.storksplows.com 130609...
Need help?
Do you have a question about the SnowEx SD-600 and is the answer not in the manual?
Questions and answers