Parts & Features - LG WCES6428F Owner's Manual

us_main.book.book Page 74 Friday, December 3, 2021 2:25 PM
74 TROUBLESHOOTING
Problem
Burning or oily odor This is normal in a new oven.
emitting from the
• This will disappear in time. To speed the process, set a Self Clean cycle for a minimum of 3
vent
Moisture collects on This happens when cooking foods high in moisture.
oven window or
• This is normal.
steam comes from
oven vent
Excessive moisture was used when cleaning the window.
• Do not use excessive moisture when cleaning the window.
Oven will not steam Improper assembly
cook (On some
• Make sure to slide the tank into the slot until it clicks into place.
models)
The drain in the water tank may be clogged with hard water scale.
• If this happens, the descaling function must be run before the steam function can be used.
Water pools in the During steam cooking, the water in the water tank is transferred to the bottom of the
bottom of the oven oven.
during or after
• It is normal for water to fill the bottom of the oven during or after the Steam mode.
steam cooking (On
• If the water leaves mineral deposits on the oven bottom, remove the deposits with a cloth
some models)
White residue Using hard water in the water tank can result in hard water scale on the oven bottom.
appears on the oven
• To remove mineral deposits that remain on the oven bottom, use a cloth or sponge soaked
bottom after steam
cooking (On some
models)
The sous vide This alert sounds when the sous vide module is operated without water in the steam
module beeps during feeder tank.
operation (On some
• Fill the steam feeder tank to the recommended level before using
models)
Parts & Features
Problem
Oven control beeps Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
The oven door is locked because the temperature inside the oven has not dropped
k is on in the display
below the locking temperature.
when you want to
cook
• Press the STOP button. Allow the oven to cool.
Oven light does not It is time to replace the bulb or the bulb is loose.
work.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner's Manual.
Cooling fan The fan turns off automatically when the electronic components have cooled
continues to run sufficiently.
after oven is turned
• This is normal.
off.
hours. See the Self Clean section.
or sponge soaked in vinegar.
in vinegar or a weak citric acid solution.
oven. If fault recurs, record fault number and call for service.
- [Case 1 ]
Code: F-9
Cause: Oven not heating (upper oven)
- [Case 2 ]
Code: F-19
Cause: Oven not heating (lower oven)
Possible Cause & Solution
Possible Cause & Solution