Table of Contents
Advertisement
1. Select the Settings Tab.
2. Click on the Channel
3. If a main receiver is plugged into a USB port, the channel number of the receiver will be
displayed on the Set Channel text box. Click on the text box to enter the channel number
you desire for the main receiver; and then click on the Send
change to the main receiver. Valid channel numbers are 0 to 40.
2.4.3 Hardware Test:
The Hardware test is used to check the communication of the main receiver, instructor remote
control, and the student keypad.
To use the hardware test tool, follow these steps:
1.
Select the Settings Tab.
2.
Click on the Hardware
Copyright © 2007 -2011 All Rights Reserved by QOMO HiteVision.
icon; this will display the Set Channel window.
icon; this will display the Hardware test window.
www.qomo.com
button to send the
108
Advertisement
Table of Contents
