Table of Contents
Advertisement
3
Please connect indoor unit and remote
controller using connection cable.
Please check if connector
is normally connected.
4
Please use extension cable if the distance
between wired remote controller and
indoor unit is more than 10 m.
5
Please fix remote controller upper part into
the setup board attached to the surface of
the wall, as the picture below, and then,
connect with setup board by pressing
lower part.
- Please connect not to make a gap at the
remote controller and setup board's
upper and lower, right and left part.
<Connecting order>
Wall
Side
When separating remote controller from
setup board, as the picture below, after
inserting into the lower separating hole
using screw driver and then, spinning
clockwise, remote controller is separated.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the
inside
components when separating.
<Separating order>
Wall
Side
REMOTE CONTROLLER INSTALLATION
When installing the wired remote controller,
do not bury it in the wall. (It can cause
damage in the temperature sensor.)
Indoor
Do not install the cable to be 50 m or above.
Unit
(It can cause communication error.)
Connecting
side
cable
• When installing the extension cable, check
• If you install the extension cable in the
• Specification of extension cable: 2547
Group Control
Signal wire
Wall
Side
1
2 When controlling multiple indoor units with
Wall
Side
CAUTION
!
the connecting direction of the connector
of the remote controller side and the
product side for correct installation.
opposite direction, the connector will not
be connected.
1007 22# 2 core 3 shield 5 or above.
GND
12 V
When installing more than 2 units of air
conditioner to one wired remote controller,
please connect as the right figure.
- If it is not event communication indoor
unit, set the unit as slave.
- Check for event communication through
the product manual.
event communication function with one
remote controller, you must change the
master/slave setting from the indoor unit.
- Indoor units, the master/slave
configuration of the product after
completion of indoor unit power 'OFF'
and then 'ON' the power after 1 minutes
elapsed sign up.
13
GND
Signal wire
Advertisement
Table of Contents
