• When unpacking, make sure that the inverter is in good condition. If any parts are missing or broken, please call AIMS Power, Inc. at the number found on the warranty card. • Place the power inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sunlight.
Page 3
supplied AC input during bypass mode. Warnings • Unplug the inverter when it is not in use. If the AC inverter makes a beeping sound, turn off the equipment, unplug the inverter and restart the vehicle’s engine. The beeping sound is simply the low-battery warning, which indicates that the voltage of your battery is getting low.
wattage. Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by operator.
on the DC input will create a voltage drop which results in a reduction of efficiency and output. If you require more than 12 feet, use a bigger cable. We recommend using an extension cord between the AC output and AC appliance. You may use up to 100ft, high quality extension cord.
SAFETY PRECAUTIONS • Do not open the case of the inverter. The high voltage inside the unit is the same type of power as your electrical outlets at home. • Do not let the cord of the inverter, or any appliance cord get wet. If you are operating the inverter in a moving vehicle, we recommend that you secure the inverter to prevent it from shifting around while the vehicle is moving.
overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to maintain a constant flow of power. • If you are not getting any power output, turn the power switch Off and On again, until the green power light comes on. Your devices may draw too much power to operate them. The inverter may be in thermal shutdown.
SPECIFICATIONS MODEL NO PWRIC150012W DC Input Voltage 12V (10-16V) Output Wave Form Modified Sine Wave Output Power 1500W Surge Power Capacity 3000W for 40milsecs Efficiency Over 90% No Load Current <1A Thermal DC 10.5 + _ 0.5 V Battery Low Alarm DC 9.5 + _ 0.5 V...
In no event shall AIMS be liable for indirect, special or consequential damages. This warranty only applies to AIMS Power branded products. All other name brand products are warranted by and according to their respective manufacturer. Please do not attempt to return non-AIMS Power branded products to AIMS Power.
Need help?
Do you have a question about the PWRIC150012W and is the answer not in the manual?
Questions and answers