Table of Contents
Advertisement
Straight Line Ripping
Refer to Figure 10
The miter bar MUST be removed when straight line ripping.
1.
Remove the miter bar from the jig base. The table saw's
fence is used to set the cutting width and guide the cut.
2.
Loosen the five star knobs on each end of the adjustable
fence and position it parallel to the jig's long edges. Tighten
the knobs. If needed, retract the adjustable stop.
3.
Place the workpiece against the jig. Position the hold down
clamps along the workpiece. Make sure they will not come
in contact with the saw blade, guard or riving knife during
6
the cut. Tighten the five star knobs to secure the workpiece.
DO NOT try to cut pieces that are too narrow to be secured
by the hold down clamps.
4.
Position the long side of the jig tight against the table saw's
fence and make the cut. Keep the jig tight against the fence
as the workpiece is fed into the blade.
Figure 10
6
GENERAL MAINTENANCE
WARNING
When servicing, use only identical replacement parts. Use of
any other parts may create a hazard or cause product damage.
To ensure safety and reliability, all repairs should be performed
by a qualified service technician.
6
Table Saw's
Fence
MAINTENANCE
WARNING
Keep the jig dry, clean, and free from oil and grease. Always
use a clean cloth when cleaning. Never use brake fluids,
gasoline, petroleum based products or any strong solvent
to clean the jig. Chemicals can damage, weaken or destroy
plastic which may result in serious personal injury.
Advertisement
Table of Contents
