First Start (Only In A Nexus Network); Initialising The Instrument; Re-Initialising The Instrument - Furuno FI-303 Operator's Manual

Wind data

Table of Contents

First start (only in a Nexus Network)

4.1

At power on, the instrument will perform a self test. The display will first show all

segments, then the software version number and the Nexus Network ID number.

At first power on after installation, you will be asked to press

SET [PrSSET]. This will give the instrument a logical ID number

on the Nexus Network.

To initialise the instrument, press SET on all installed digital

instruments, one at the time.

Note: Always wait for the text "Init OK"

to be displayed, before you press SET

on the next instrument!

The Server automatically gives the first unit ID number 16, then

17 and so on. The order in which you press SET is the same

order as the instruments will be given a logical ID number on

the Nexus Network.

The example shows that the instrument version number is 1.00

and the given logical ID number is 16.

4.2

If two instruments by mistake have the same ID number, this can cause disturbance

and block the information on the Nexus Network.

To re-initialise the instrument, press MINUS and PLUS together

during the power up sequence when version and ID numbers

are displayed.

The display self test is then re-started on all instruments and you will be asked to press

SET on each instrument as explained above.

Note! If you do not succeed to re-initialise, we suggest you disconnect all but one

instrument with the same ID number, then repeat the above procedure.

Table of Contents