Bosch CL400 Manual page 68

7- -16 General Information Regarding BUEP-E and BUEP19E
Error during command execution on the partner module PST
Error Information [hex]
Reaction Class
01 40
03 40
01 40
03 40
03 40
03 40
03 40
03 40
03 40
03 40
03 40
03 40
03 40
01 40
01 41
01 41
03 41
01 41
01 41
03 41
03 41
03 41
03 41
01 41
Explanation
Code PW
02 Memory access error
03 4 Wrong memory type, e.g. write access on EPROM
05 Internal error during processing of the command on the PST
10 10 No module exists for the specified PST block address
20 5 PST command code unknown
23 13 Invalid coordination marker on the PST
26 12 Block length error
3A 4, 11 Wrong address orientation, e.g. writing a word on odd addresses
3B 11 Invalid address range
3C 9 Invalid parameter
3D 4 Invalid type of operand
63 Buffer overflow; data length is greater than the available memory of 200
bytes.
D2 13 Coordination marker disabled.
xy Module-specific error.
20 STOP error; the module is in the STOP state. The specified command
cannot be executed.
21 RUN error; command cannot be executed in RUN.
23 4, 5 Field access not allowed; the desired access (read/write/bit) is not appli-
cable for this field.
24 Field protection active; at the moment, the desired field is reserved by
another position.
25 Timer disabled; actual time values can only be changed when time is
running.
26 9 Module number too high; higher than the allowed maximum value.
27 9 Data module not available, in the PST.
28 11 Data module too small, in the PST.
2B Data Error during writing on the system clock.
xy Module-specific error.
H
1070 072 196-101 (00.06) GB