Noise Level; Hoisting Device; Hoisting Cable; Spare Parts - Landustrie DCP22 Operation & Maintenance Manual

Installation "VRS"
This installation represents freestanding submerged installation.
Points of attention:
 Ensure a good free passage under the pump, at least
identical to the suction opening.
 Adjust start- and stop levels in such a way that the motor
will not make more than 20 starts per hour.
 Check that the motor is adequately cooled.
At full load conditions, at least 2/3 of the motor housing should
be submerged.
 The pump casing must stay under water to avoid air being drawn in.

Noise level:

Pump installations in sumps, with closed cover, the noise level will not exceed 70 dB(A).

Hoisting device:

Submersible pumps can be hoisted out of the sump by means of an
adequate lifting device. Landustrie is able to deliver this certified equipment.

Hoisting cable:

If applied, please replace the stainless steel hoisting cable every two years, or
accordingly to local regulations.

Spare parts:

When ordering spare parts, please specify the following data:
Pump type, product code and the serial number.
This information is available on the data plate of the pump.
For ordering spare parts please contact your supplier.
Parts list and sectional drawings are available on request.
Landustrie versie 01-21 | Operation & maintenance manual DCP22
Subject to modifications
6 / 16