Figure 27: Connecting the server to the DC voltage - example DC PSU -48 V
▶ Connect the power cord to the PSU (1).
▶ Fasten the two studs (2).
▶ Ensure that the status indicator on the PSU is lit green, see
hot-plug PSU" on page
▶ If necessary, make a permanent connection to the distribution board.
CAUTION
If the server/rack is intended for permanent connection to the mains only
an authorized specialist (electrician) is allowed to work.
▶
Please follow the regulation of each country.
It will take about 60 seconds until the server can be switched on.
RX2540 M6
45.
Operating Manual
Starting up
"Indicator on
75