Table of Contents
Advertisement
System Configuration
User Name
Password
Telnet Enable
Access Control
Wireless Configuration
SSID
Country
RF Channel Frequency
Data Rate (Mbps)
Transmit Power
Beacon Interval (20 - 1000)
Data Beacon Rate (1 - 255)
Description
Specifies the user name.
Specifies the password.
Use the checkbox to allow telneting into the
system.
Specifies the MAC address allowed to join.
Description
Identification of the BU. Enter a number or
address between 1 and 32 characters in length
that the RU is associating with. Use the System
Name field to uniquely identify each BU..
Display country name; it's related to channel
frequency base.
Select the desired frequency of operation from
the drop-down menu, or choose SmartSelect.
The radio frequencies that appear in the Radio
Channel drop-down menu are dependent on
the wireless mode selection. Select
"SmartSelect" to automatically search through
the frequency list to find a used or less
congested channel. It only works on AP
system. AC will scan the right channel.
Specifies rate of data transmission. Select the
desired rate from the drop-down menu. The
Best selection will adapt the rate to the best
available. Value unit in Mega bit per second
Specifies the level of transmit power. Choose
the value of the transmit power from the
dropdown menu. Decrease the transmit power
if more than one AP is co-located using the
same channel frequency. Maximum transmit
power depends on channel frequency. In
selected item, 'Full' means maximum transmit
power; 'Half' means Full – 3dB; 'Quarter'
means Full –6dB; 'Eighth' means Full –9dB;
and 'Minimum' means 0dB.
Specifies the beacon interval value. Enter a
value between 20 and 1000. It only works on
AP system.
Specifies the Data Beacon Rate. Enter a value
between 1 and 255 that specifies the delivery
traffic indication message (DTIM). It only works
on AP system.
11
Advertisement
Table of Contents
