Amp Ctl (Standby / Amplifier Control); Power Led - SPL Professional Fidelity Series User Manual

AMP CTL (Standby / Amplifier Control)

If you own an SPL device supporting AMP CTL output(s) you can trigger standby and
operation. Therefore connect the AMP CTL output of the SPL device with a mono mini
jack cable to the AMP CTL (10)
You may also use other 12V trigger controller. The Performer s1200 is in operation
mode when a switching voltage of 12 Volt DC is applied to the AMP CTL input.
As soon as the 12 Volt DC is removed, the Performer s1200 switches back to
standby mode.
Use a mono mini jack cable where the tip is plus and the sleeve is minus.

Power LED

In standby the Power LED is dimly lit.
If the Performer s1200 is in operation, the Power LED lights up brightly.
If the Performer s1200 is off, e.g. the mains switch is off, the Power LED is off.
16
of the Performer s1200.
Tip
Sleeve
+ –
R
2
AMP CTL (Standby / Amplifier Control)
Minimum Load
SPEAKER OUTPUT RIGHT
I F R
– +
L
2
Minimum Load
SPEAKER OUTPUT LEFT
Connect to
AMP CTL output of
SPL Preampli er/DAC
for remote power on/o
OR
Use V Trigger
AMP CTL/ V TRIGGER
Pin = GND
Pin = Hot (+)
Pin = Cold (–
XLR WIRING