Cleaning The Electrode Pad - TensCare Sonic Stim + Manual

7.4. Cleaning the electrode pad

1) Switch the power off and remove the pad from the skin and the lead wire.
2) Wash the pad when the adhesive surface becomes dirty and/or the pad
is difficult to attach to the skin.
• Wash the pad softly with your fingertips under slow running cold
water for several seconds (do not use a sponge/cloth/sharp object
like a nail on adhesive side, do not use detergents, chemicals or
soap).
3) Dry the pads and let the adhesive surface air-dry completely (do not
wipe with a tissue paper or cloth).
4) Replace the pad on the clear plastic film and store in plastic bag.
Caution: The life of the electrode pad may vary by the frequency of
washing, skin condition, and storage state.
Caution: If the electrode pad no longer sticks to your skin or the
electrode pad is broken, you should replace with a new electrode
pad.
Caution: Before applying the electrode pad, it is recommended to
wash and degrease the skin, and then completely dry the area.
Caution: Do not turn on the device when the electrode pad is not
positioned on the body.
Caution: Never remove the electrode pad from the skin while the
device is still powered on.
Caution: If a replacement electrode is necessary, use only electrode
pads that are 2 inch x 4 inch (50*100mm), the same as the electrode
pad provided with the Sonic Stim + device.
Caution: Use of electrode pads larger than provided may reduce
the effect of the stimulation. Use of an electrode pad that is much
smaller than the electrode pad provided with Sonic Stim + device
may increase the chance of skin irritation or electrode burns
occurring under the electrode pad.
Caution: Always use electrode pads that CE marked.
19