The Applicator - TensCare Sonic Stim + Manual

current density of 2 mA r.m.s./cm
For current types that contain a DC component we recommend not to
exceed a current density of 0.2 mA/cm
8) Start treatment
Move the treatment head in a flat, slow, circular motion
over the skin surface treatment area that is covered
with a layer of ultrasound transmission gel. Apply the
head evenly (in time) over the treatment area.
Caution: The device has a load detection
system for safety. If the electrode pad or the
ultrasound treatment head do not have
good contact with the skin, the STIM LED and TIME LED will flash and stop
treatment after the output intensity of stimulation surpasses 5V. The intensity
will automatically but slowly increase to the setting level after the pad and
treatment head have made good contact with the skin.
Caution: The device has a temperature protection function. When
the temperature of the treatment head exceeds 42°C the
treatment will automatically stop and the TIME LED will flash quickly
(2Hz). The device will not restore treatment until the temperature is below 40°C.
Caution: The device works without vibration. You must move the
applicator with a slow but deliberate speed, flat against the
treatment area and in a circular motion around the treatment area.
After finishing the treatment, the device will enter the waiting state. It is not
recommended that the user restart treatment upon completion of therapy.
9) Turn off the device
After the time duration has been completed, the device will automatically
revert to standby state. Once your therapy session has been completed, turn
off the product by sliding the ON/OFF switch downwards from ON to the OFF
position.

6.3. The applicator

The applicator is a precision instrument. Great care is taken in the
development and
, otherwise skin irritations or burns can occur.
2
production to
2
.
obtain the best
17
possible beam