Operating The Device - TensCare Sonic Stim + Manual

• If experiencing poor transmission of ultrasound energy, it is advised to add
more gel or reposition the ultrasound-head.
Caution: The ultrasound-head should be moved in a slow, flat,
circular motion over the skin surface of the treatment area. Apply
the sound head evenly (in time) over the treatment area; not too
slow to avoid inducing heat; not too fast to prevent bad contact which would
reduce the effectiveness of the treatment.
After treatment
• Clean the contact surface immediately after each treatment. Make sure
that no ultrasound gel remains on the treatment head. We recommend
cleaning the head and cable daily, using lukewarm water - do not
immerse the device in water.
• The treatment heads can be disinfected using a cloth moistened with 70%
alcohol.
• Check if there are any signs of improvement (e.g. pain, circulation or
mobility).

6.2. Operating the device

6.2.1 Ultrasound Therapy
1) Apply Transmission Gel
Apply a layer of ultrasound transmission gel on the
treatment area. The gel acts as a coupling substance
and ensures effectiveness. The area treated should be
two times the diameter of the treatment head.
Caution:
applicator. The applicator will register this as contact and may emit
ultrasound energy, which could damage the applicator.
2) Switch on the device
Connect the power adapter according to section 5.3.
Switch on the device, using power on/off switch by
switching from OFF to ON position. The Power LED will
light green.
Never apply the gel to the
13