BCM Advanced Research Advanced Socket 370 User Manual page 24

BIOS Setup
4.3.4 First Boot Device
This option sets the type of device for the first boot drives that the BIOS attempts to boot
from after BIOS Post completes.
4.3.5 Second Boot Device
This option sets the type of device for the second boot drives that the BIOS attempts to boot
from after BIOS Post completes.
4.3.6 Third Boot Device
This option sets the type of device for the third boot drives that the BIOS attempts to boot
from after BIOS Post completes.
4.3.7 Fourth Boot Device
This option sets the type of device for the third boot drives that the BIOS attempts to boot
from after BIOS Post completes.
4.3.8 Power Up NumLock
Toggle between "On" or "Off" to control the state of the NumLock key when the system
boots. When toggled on, the numeric keypad generates numbers instead of controlling cursor
operations.
4.3.9 Select Primary VGA
Select Primary display type.
4.3.10 Boot Sector Protection
When enabled, you receive a warning message if a program (specifically a virus) attempts to
write to the boot sector or the partition table of the hard disk drive. You should then run an
anti-virus program. Keep in mind that this feature protects only the boot sector, not the entire
hard drive.
NOTE: Many disk diagnostic programs that access the boot sector table can trigger the virus-
warning message. If you plan to run such a program, we recommend that you first disable the
virus warning.
4.3.11 Password Required on
Enable Password protection to system setup.