Maintenance And Inspection - Canon CX-1 Operation Manual

Handling
! CAUTION
! CAUTION
! CAUTION
! CAUTION
When Problem Occurs
! WARNING

Maintenance and Inspection

! WARNING
WARNING
!
WARNING
!
! WARNING
! CAUTION
To ensure cleanliness, replace the chin rest paper whenever changing patients.
When adjusting the forward position of the main unit, be sure to move the main unit
slowly toward the patient while looking from the side of the patient, so as to prevent
accidental contact of the objective lens with the patient.
Do not place your hand or fingers between the stage and base. Also, ensure that the
patient does not place his/her hand or fingers there either. Otherwise, fingers may be
hurt.
When the instrument is not going to be used, turn OFF the power.
Also, unplug the power cable from the AC outlet when it is not going to be used for a
long time.
Should any of the following occur, immediately turn OFF the power of each
instrument, unplug the power cable from the AC outlet, and contact a Canon
representative or distributor.
• When there is smoke, an odd smell or abnormal sound.
• When liquid has been spilled into the instrument or a metal object has entered
through an opening.
• When the instrument has been dropped and it is damaged.
For safety reasons, be sure to turn OFF the power when the inspections indicated in
this manual are going to be performed. Otherwise, it may result in electric shock.
When the instrument is going to be cleaned, be sure to turn OFF the power, and
unplug the power cable from the AC outlet.
Never use alcohol, benzine, thinner or any other flammable cleaning agents.
Otherwise, fire or electric shock may result.
Clean the plug of the power cable periodically by unplugging it from the AC outlet
and removing dust or dirt from the plug, its periphery and AC outlet with a dry cloth.
If the cable is kept plugged in for a long time in a dusty, humid or sooty place, dust
around the plug will attract moisture, and this could cause insulation failure which
could result in a fire.
The instrument must be repaired by a qualified engineer only.
If it is not repaired properly, it may cause fire, electric shock, or accident.
For safety reasons, be sure to inspect the instrument before using it.
(5)
Safety Information