General Information; Installation; Door Removal - Viking RVDR33025BSS Installation Manual

Freestanding 30” dual fuel self-clean sealed burner range
Table of Contents

Advertisement

General Information

READ AND FOLLOW ALL WARNING
Moving, Handling, and Unpacking
AND CAUTION INFORMATION
Remove and discard all packing materials,
WHEN INSTALLING THIS APPLIANCE.
including cardboard and tape on the outside
and inside of the range.
• All openings in the wall behind the
appliance and in the floor under the
Remove the cardboard top pack containing
appliance must be sealed.
the burner heads, burner caps, grates, leveling
legs and anti-tip bracket from the top of the
• DO NOT obstruct the flow of combustion
range.
and ventilation air.
DO NOT discard the anti-tip
CAUTION
metal brackets (2) supplied
with the range. These are the
Avoid any damage to oven vents. The vents
anti-tip devices and one must
need to be unobstructed and open to provide
be installed with the unit.
proper airflow for optimal oven performance.
Refer to "Anti-tip Device
Installation" section.
CAUTION
Some stainless steel parts
The cooling fan should be operating when
may have a plastic protective
the unit is in operation. If you notice the
wrap which must be peeled off. The interior
cooling fan is not operating or you observe
should be washed thoroughly with hot,
unusual or excessive noise coming from the
cooling fan, contact a Viking Authorized
soapy water to remove film residues and any
Service Center before continuing operation.
dust or debris before being used, then
Failure to do so can result in damage to the
rinsed and wiped dry. Solutions stronger
oven or surrounding cabinets.
than soap and water are rarely needed.
12

Installation

NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.

Door Removal

1
Open door completely. Place pins, supplied
Remove hinge trim screws. Take off hinge trim. Identify
with unit, in pin holes. For personal safety, ONLY use
pins supplied with the unit.
3
Gently close until pins stop door.
13
2
right and left hinge for future re-installation.
4
Lift door up and out.

Advertisement

Table of Contents
loading

This manual is also suitable for:

3 seriesRvdr33025bsslp

Table of Contents