Table of Contents
Advertisement
Leg Installation
1
Legs are packed in the cardboard top pack.
Note: Legs should be installed near to where
appliance is to be used, as they are
not secure for long transit.
3
Screw legs into couplings on all
four corners.
14
2
1
1
3
2
2
Note: It is strongly recommended
that a pallet or lift jack be used rather than tilting.
Raise unit about a foot. Unscrew temporary legs
from couplings .
4
Lower range gently to keep any undue strain from
legs and internal mounting hardware.
Electrical Connection (3-wire)
Note: If you have a 4-wire connection, see following section for
4-wire connection instructions.
WARNING
ELECTRICAL SHOCK
HAZARD
To avoid risk or electrical
shock, personal injury or death;
grounding product to the frame of the unit
your appliance has been properly
may or may not be permitted through
grounded in accordance with local codes
your local codes. If ground to the frame is
or in absence of codes, with the National
not permitted then a 4-conductor power
Electrical Code (NEC) ANSI/NFPA-70 –
cord must be used.
latest edition.
Use a 3-wire power supply cord kit rated for
40 amps – 125/250 volts with closed loop
terminals and marked for use with ranges.
Where local codes do not permit grounding
through neutral, use a 4-wire power supply
cord. The cord or conduit must be secured
to the range with the strain relief bracket.
The electrical connection is made at the
terminal block, which is located behind the
access door on the back of the range.
2
3
Remove supply cord strain relief
bracket and three supply cord mounting screws
on terminal block.
15
WARNING
ELECTRICAL SHOCK
HAZARD
To avoid risk of electrical shock,
personal injury or death; verify
1
Remove access door.
3
Feed supply cord up through hole in bottom
of range back.
Advertisement
Table of Contents
